altium designer tutorial create a component library

Especially when it is being developed, it is effortless to go off track and end up with something that you did not intend to have and are unable to use. The third principle regarding your library is that you must protect it with everything in you. For more information regarding a Naming Convention, check out my blog on the subject. The more specific components, such as the ICs, can have the manufacturer part number as the name. It is difficult to identify a component in your library by the MFG part number. So, a 1K resistor would use the value rather than Manufacturer information. In a nutshell, the generic components, such as your discrete parts that will have multiple sources, should be a simple value. There is a lot that I wrote about this subject and several different methods that I have tried. This will involve having a conventional naming scheme for both your components and models. Secondly, the structure of your library should be in such a way that things can easily be identified and found. Your library should easily be expandable without causing “growth pains.” This was a big problem for us when we started to build up our library, we found that we did not accommodate for the growth that we would see in the company and ultimately in the component library. Some basic principles will help as you begin to structure all this. It just depends on which column of the balance sheet it falls on as an asset or as a loss. However, we need to change the way that we look at it. At first glance, the library is merely a collection of data and information for the components. The component library and the integrity of that library will determine the quality of your PCBs.

What you are about to start is the most important in your PCB designs. Because it is difficult to change them once we begin to actually start components. It is essential to have them in place now rather than later. These will be the building blocks that we use to structure our Component Library throughout this blog. “Are you ready for your next step?” By now, you should have set up the following:

Before anything else, I must ask a question.

Altium designer tutorial create a component library